安装好后运行 vmware 要我
vmware is installed, but it has not been (correctly) configured
for this system. To (re-)configure it, invoke the following command:
/usr/bin/vmware-config.pl.
我又运行config
make: Leaving directory `/tmp/vmware-config0/vmnet-only'
The module loads perfectly in the running kernel.
Starting VMware services:
Virtual machine monitor [ OK ]
Virtual ethernet [ OK ]
Bridged networking on /dev/vmnet0 [FAILED]
Host-only networking on /dev/vmnet1 (background) [ OK ]
Host-only networking on /dev/vmnet2 (background) [ OK ]
NAT service on /dev/vmnet2 [ OK ]
Host-only networking on /dev/vmnet3 (background) [ OK ]
NAT service on /dev/vmnet3 [ OK ]
Host-only networking on /dev/vmnet4 (background) [ OK ]
NAT service on /dev/vmnet4 [ OK ]
Host-only networking on /dev/vmnet5 (background) [ OK ]
NAT service on /dev/vmnet5 [ OK ]
Host-only networking on /dev/vmnet6 (background) [ OK ]
NAT service on /dev/vmnet6 [ OK ]
Host-only networking on /dev/vmnet8 (background) [ OK ]
NAT service on /dev/vmnet8 [ OK ]
The configuration of VMware Workstation 5.0.0 build-13124 for Linux for this
running kernel completed successfully.
You can now run VMware Workstation by invoking the following command:
"/usr/bin/vmware".
Enjoy,
--the VMware team
最后
[root@MagicLinux bin]# vmware
vmware is installed, but it has not been (correctly) configured
for this system. To (re-)configure it, invoke the following command:
/usr/bin/vmware-config.pl.
已经配置过一次 了还是老样子 具体 是哪出问题呢？？？
