我是新手！我在运行编译好的uclinux时，
用skyeye -e linux-2.4.x/linux运行时，可以成功，
如下：
。。。。。。。
。。。。。。。
Command: mkdir /var/empty
Command: cat /etc/motd
Welcome to
          ____ _  _
         /  __| ||_|
    _   _| |  | | _ ____  _   _  _  _
   | | | | |  | || |  _ \| | | |\ \/ /
   | |_| | |__| || | | | | |_| |/    \
   |  ___\____|_||_|_| |_|\____|\_/\_/
   | |
   |_|

GDB/ARMulator support by <davidm@snapgear.com>
For further information check:
http://www.uclinux.org/

Execution Finished, Exiting

Sash command shell (version 1.1.1)
/>
直接进入了uclinux提示符下!

但为何不会出现(SkyEye)提示符，让输入tar sim,load,run等呢？


我再用skyeye linux-2.4.x/linux尝试，
就出现如下：

**************************** WARNING **********************************
If you want to run ELF image, you should use -e option to indicate
your elf-format image filename. Or you only want to run binary image,
you need to set the filename of the image and its entry in skyeye.conf.
***********************************************************************

Non-option argument linux-2.4.x/linux
big_endian is false.
arch: arm
cpu info: armv3, arm7tdmi, 41007700, fff8ff00, 0
mach info: name at91, mach_init addr 0x8062194
uart_mod:0, desc_in:, desc_out:, converter:
SKYEYE: use arm7100 mmu ops
Loaded ROM   ./boot.rom
然后就停在了这里！

请高手指点一下！！！

难道一定要用skyeye -e？

怎么才能运行时出现(SkyEye)提示符？

我用的skyeye是最新版本，难道新版本的做了改变？

请高手解惑！！

为什么都没回复呢？
再次请高手指点一二！

In new version of Skyeye(after 1.0), we have to use -e option to run our elf image.
Before 1.0 version of SkyEye, you can enter Skyeye prompt by Ctrl + C, and run some commands such as "target sim" etc. If you like to use old skyeye, you can download skyeye-0.98 version from
http://sourceforge.net/project/showfiles.php?group_id=85554

果然和我猜想的一样！！
谢谢楼上的老兄！
我这就去下个老版本的玩一玩！