我现在用的是skyeye 1.23。

最近在调试 USART的读写程序(个人按照手册的提示写的)
但是我这边因为用的是笔记本，所以没有 串行口 因此，我想问一下如何使用键盘作为USART的输入，终端作为USART的输出。或者以普通文件作为USART的输入和输出。

谢谢赐教。

另外，想问一下，如何在skyeye中人为模拟产生硬件中断信号，比如CPU进入休眠状态，那么人为的在skyeye中模拟一个外部中断信号来将CPU唤醒，请问这个唤醒的外部中断如何在skyeye中模拟？

1. 当前skyeye默认用键盘和终端来作为usart的模拟输入和输出。具体代码在device/uart/skyeye_uart_stdio.c
2. 在每一个开发板模拟代码中的io_do_cycle函数，如skyeye_mach_ep7312.c的io_do_cycle函数。设置中断标志，并且跳转PC到中断处理函数

可是我这边的代码无法被正常执行。

我的C代码如下


我的skyeye的配置文件


当我向用键盘输入时，什么也没反应。可是按照代码，我每次输入都应该输出一个M的。

Please read helloworld example in this board.
http://www.linuxfans.org/bbs/thread-82187-1-1.html
You will get some idea from it.

那个我看过了，我的代码是按照手册上来的。应该没有问题的。

而且，我可以在屏幕上输出数据，但是，不能从键盘读数据

Try to debug it. I also think that should not be the mistake of SkyEye. At least uCos and uClinux for at91 can run correctly on SkyEye.

调试过了，代码没有问题。那如果既不是我的问题，按照KSH的说法，也不是skyeye的问题～，那这个是谁的问题呢？
我觉得推卸责任不是解决之道，不知道KSH接下来是不是又要说，It maybe the matter of your computer,.....？？？

I read the source code of skyeye and datasheet. There is two issues:
1. Perhaps RCR register need to be initialized before read data to RHR. Is it necessary? I am not familiar with the usart of AT91. There is a description related to it:
RXCTR must be loaded with the size of the receive buffer.

2. The implementation of SkyEye also is not incompletely. CSR is not set correctly.

Thanks your report.

[ 本帖最后由 ksh 于 2007-12-24 00:01 编辑 ]

I read the source code of skyeye and datasheet. There is two issues:
1. Perhaps RCR register need to be initialized before read data to RHR. Is it necessary? I am not familiar with the usart of AT91. There is a description related to it:
RXCTR must be loaded with the size of the receive buffer.

2. The implementation of SkyEye also is not incompletely. CSR is not set correctly.

Thanks your report.